{当前产品的产品关键词轮巡使用}
2026-10-08

A Guide to Adhesive Application Methods

Selection Principles
(1) Consider the type, properties, size, and hardness of the materials to be bonded;
(2) Consider the shape, structure, and processing conditions of the materials;
(3) Consider the magnitude and nature of the loads acting on the bonded joint (e.g., tensile, shear, or peel forces);
(4) Consider special material requirements, such as electrical conductivity, thermal conductivity, and resistance to high or low temperatures.
Properties of Materials to be Bonded
(1) Metals: Metal surfaces are easy to bond after surface treatment to remove oxide layers; however, significant differences in the coefficients of linear thermal expansion between the metal and the adhesive can lead to internal stress within the adhesive layer. Additionally, bonded metal joints are susceptible to electrochemical corrosion caused by moisture.
(2) Rubber: Bonding performance generally improves with higher rubber polarity. Nitrile and chloroprene rubbers exhibit high polarity and yield strong bond strengths, whereas natural rubber, silicone rubber, and isobutylene rubber have low polarity and weaker adhesion. Furthermore, the presence of mold release agents or other migrating additives on the rubber surface can impair bonding effectiveness.
(3) Wood: As a porous material, wood readily absorbs moisture, leading to dimensional changes that may cause stress concentrations. Additionally, polished wood surfaces generally offer better bonding performance than rough surfaces.
(4) Plastics: Plastics with high polarity generally exhibit good bonding properties.
(5) Glass: At a microscopic level, the glass surface consists of countless uneven irregularities. Adhesives with good wettability should be used to prevent air bubbles trapped in these irregularities from compromising the bond. Additionally, glass features a primary Si-O structural backbone, and its surface readily adsorbs water. Due to the high polarity of glass, polar adhesives easily form hydrogen bonds with the surface, resulting in a strong bond. Factors such as the material's brittleness and transparency must be considered when selecting an adhesive.
Characteristics and Selection
(1) Capable of joining materials with varying elastic moduli and thicknesses, particularly thin materials;
(2) Results in a smooth bonded surface with good aerodynamic properties;
(3) Offers excellent sealing and corrosion resistance;
(4) Extends the service life of bonded components and reduces their weight;
(5) Involves low labor intensity, reduced costs, and high production efficiency;
(6) Non-conductive adhesives offer heat resistance, shock resistance, and electrical insulation; specifically:
a. The order of flexibility for modified epoxy resins is: epoxy-polysulfide > epoxy-polyamide > epoxy-amine curing agent;
b. The order of flexibility for modified phenolic resins is: phenolic-polyamide > phenolic-polyvinyl acetate > phenolic-epoxy;
Key Quality Points
To ensure bonding quality, the following measures must be taken:
(1) Select the appropriate adhesive for the application.
(2) Balance the requirements for both high strength and good durability.
(3) Do not use adhesives that have exceeded their shelf life or pot life.
(4) Stir single-component adhesives thoroughly before use if separation or sedimentation has occurred.
(5) Mix multi-component adhesives thoroughly according to the specified ratios.
(6) Avoid simple butt joints.
(7) Whenever possible, use lap joints, scarf joints, sleeve joints, or hybrid joints.
(8) Do not make lap joints excessively long.
(9) Use scarf joints rather than lap joints for bonded laminated materials.
(10) Incorporate screws, rivets, hemmed edges, or wrapped corners to prevent delamination.